Our services

21-point cooling inspection: coils, refrigerant levels, electrical connections, condensate drain, and airflow.

Heating season readiness: burners, heat exchanger inspection, gas pressure, safety controls, and CO check.

Full system diagnostic by a licensed tech. Diagnostic fee applies toward the repair.

Leak check plus refrigerant top-off to factory charge.

Supply and install a smart thermostat, configure schedules, and walk you through the app.

Remove and replace condenser + coil, new pad and disconnect, full commissioning.

High-efficiency furnace swap including flue, gas, and condensate connections.

Single-zone ductless heat pump: line set, electrical, and commissioning.

Dead circuits, nuisance breaker trips, flickering lights — diagnosed and quoted on the spot.

Replace fuse box or undersized panel with a 200A panel, new grounding, and labeling.

Dedicated 240V circuit and Level 2 charger install, load calculation included.

Panel-mounted surge protective device to guard electronics and appliances.

Fan-rated box, assembly, and balanced installation (existing switch loop).

Replace worn or non-grounding devices; GFCI/AFCI where code requires.

Six LED recessed fixtures on a dimmer, patched and paint-ready.

Manual transfer switch with inlet box for portable generator backup.

Leaks, low pressure, odors — inspected and quoted before any work begins.

Power auger the main line through cleanout; camera verification on request.

Like-for-like tank swap: new supply lines, pan, expansion tank where required, haul-away.

Condensing tankless conversion: venting, gas upsizing, isolation valves.

Supply and install 1/2–3/4 HP disposal, new flange and connector.

Comfort-height elongated toilet, new wax ring and supply, haul-away.

Repair accessible supply or drain leak — compression, solder, or PEX.

1/3–1/2 HP pump with new check valve and float test.